DJI T100 T70P Lift System complete visual manual map

DJI T100/T70P Lift System User Manual: Setup, Preflight, Sling, Calibration, Task Planning & Operations

September 18, 2026

This visual hub reorganizes DJI's T70P / T100 Lift System User Manual v1.0 (2025.07) into focused field tutorials. The source is concise and highly procedural, so the cluster follows the manual's natural sequence: safe environment → preflight and rigging → installation and tare calibration → task-point planning → loading/unloading → swing and battery management.

Quick Answer: Before a lift, operate only in the source-defined weather/GNSS limits, inspect the payload system, use the DJI Agras recommended payload limit, and verify the sling/hook. Install using DJI's official guidance and tare-calibrate if unloaded measured weight does not equal zero. Plan points in Agras Lift mode, manually route around obstacles, then use the FPV/AR cargo-handling sequence with ground-contact and crew separation.

T70P T100 lift system visual manual map setup preflight rigging planning operation — Visual map of the manual cluster.

Lift system visual manual index

Environment and preflight

T100 T70P lift weather GNSS altitude and distance limits — DJI's operating boundaries include 0-40°C, wind not exceeding 6 m/s, strong GNSS and a maximum altitude of 4.5 km above sea level.

The manual also requires the operator to inspect propulsion, sensors, radar, LiDAR, payload hardware, cables and app warnings before flight. DJI Agras recommends the lift payload limit according to the aircraft's current condition and surroundings rather than the manual publishing one fixed number here.

Rigging and crew safety

T100 T70P lift sling rope and hook specifications — Sling: 10-15 m, ≥8 mm, UHMWPE or aramid fiber; hook pulling force ≥500 kg. Ground crew stay at least 6 m away.

Installation and tare calibration

T100 T70P lift installation prep and tare calibration sequence — Remove the flight battery before installation and tare-calibrate if the unloaded measurement does not return to zero.

DJI's manual points users to the official T70 and T100 tutorial videos for installation and connection. Existing Ares Acres articles already cover T100 dual-battery lift installation and lifting-interface calibration, so this cluster links into those resources instead of reproducing the same mechanical tutorial.

Task-point planning

Performing an operation

T100 T70P lift operation destination FPV cargo ground 3 to 4 meters 6 meter crew zone — Lower until the sling/cargo touches ground, continue down 3-4 m, then move about 6 m away before the crew approaches.

T100 T70P lift Auto Balance Control and battery overheating response — DJI Agras provides Auto Balance Control; land promptly if the app reports battery overheating.

Official DJI resources

The source provides official tutorial-video paths at ag.dji.com/t70/video and ag.dji.com/t100/video. It also points users to DJI SmartFarm for operation support.

No separate specifications article from this PDF

The Appendix does not publish numerical lift-system specifications. It directs operators to DJI's current T70 and T100 specification pages. For that reason, this cluster does not invent a standalone “specifications” article from values that are not contained in the manual.